Threads can get bunched up at the beginning of sewing if the top and bobbin threads have not been properly placed underneath the presser foot before starting to sew. Ensure that both threads are under the presser foot and placed toward the back of the machine before lowering the presser foot to start sewing.
How do I fix bobbin thread bunching?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
Why does my sewing machine keep jamming underneath?
However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.
Why is my sewing machine bunching thread?
What should I do if I experience thread bunching? As “thread bunching” occurs on the underside of the fabric, some people think it is due to the lower thread. They check whether the bobbin is sitting correctly in the bobbin case or even replace the bobbin. … On many models, the upper thread tension is set automatically.
How do you adjust the bobbin tension on a Singer sewing machine?
Place a small screwdriver on the head of the screw on the side of the bobbin case. Turn very slightly clockwise to increase the tension on the Singer bobbin. Turn slightly counterclockwise to decrease the bobbin tension.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
Why is my bobbin case keeps popping out?
The most common cause of this problem is when the bobbin holder’s finger isn’t placed in the small groove located in the needle plate. The best solution, therefore, is to ensure your bobbin holder finger is perfectly fitted in the needle plate.