First, make sure the bobbin-winding spindle (located on top of your machine) has been pushed back to the left for sewing. If it is not in the correct position, the needle will not go down and pick-up your bobbin thread. … Make sure the presser foot is up when seating the thread through the upper tension.
Why is my thread looping underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
What should tension be set on sewing machine?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
Why won’t the thread stay in when I sew?
If the tension on the top thread is too high or low the machine can often keep unthreading. Make sure the thread has the correct tension and if your stitches are loose you should probably try to tighten the thread a bit. … If you are using a wrong size spool the thread might jump out of the needle continuously.
Why is my sewing machine stitching loose?
The machine is not correctly threaded
If the machine is threaded wrong, not only does it make the thread breaks easier, but is also more likely to create loose stitches. Check the threading to see if the thread has passed through the entire thread guides, the take-up lever and the eye of the needle.
How do you fix bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
When should I adjust the tension on my sewing machine?
When lower tension is too loose (or upper tension is too tight), knot is visible on right side (left). When upper tension is too loose (or lower tension is too tight), knot is visible on wrong side (right). Tensions can still need adjustment even if they’re balanced.
How do I stop my thread from breaking on my sewing machine?
Sewing Machine Thread Keeps Breaking | Top 10 TIPS
- TIP #1: NEEDLES.
- TIP #2: BOBBIN.
- TIP #3: RE-THREADING.
- TIP #4: THREAD QUALITY.
- TIP #5: THREAD SNAGS.
- TIP #6: CLEAN THROAT PLATE.
- TIP #7: THROAT PLATE CONDITION.
- TIP #8: DON’T PULL.
Why is my bottom stitch not straight?
If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.
How do you tighten thread tension?
Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension. Some quilters keep two bobbin cases on hand, leaving one as-is from the factory and using the other when they need to make adjustments.