Insert the bobbin making sure the bobbin rotates counterclockwise when you pull the thread. NOTE: This is a very important step as the bobbin can become unthreaded and cause sewing problems if it rotates clockwise.
Does it matter which way the bobbin thread go?
Make sure the bobbin thread unrolls in the correct direction when installing the bobbin into the bobbin case. Be sure to set a bobbin so that the thread unrolls in the correct direction. If the thread unrolls in the wrong direction, the needle may break or the thread tension will be incorrect.
Should the bobbin case spin?
If you are sure it is the bobbin case here’s what you need to do. You need to make sure that the bobbin case is inserted properly. Start by turning the handwheel towards you until the needle is in it’s highest position. … When you insert the bobbin case it should always click in place.
Why isn’t my bobbin thread coming up?
If it is not in the correct position, the needle will not go down and pick-up your bobbin thread. … Also, make sure your bobbin is in correctly (not backwards) and that the upper tension disks of your machine are threaded correctly. Make sure the presser foot is up when seating the thread through the upper tension.
What happens when you use the wrong bobbin?
The short answer is YES! Filling a sewing machine bobbin too tightly can make a plastic bobbin bulge or stretch the thread if you are using a metal bobbin. This may be hard to see but can cause all kinds of problems. Plastic bobbins can become compressed in the center causing the bobbin to distort.
Which side is the bobbin thread?
BOBBIN WORK is a technique where the bobbin holds a heavier decorative thread that is hand-wound onto the bobbin and the stitching is done on the wrong side of the fabric, laying the decorative thread on the right side.
Does the bobbin thread go through the needle?
Thread from the spool goes through the needle’s eye. Thread from the bobbin comes up through the needle plate.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
How do you fix bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
Why does my sewing machine keep jamming underneath?
However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.