The amount of pressure is regulated by a small screw at the rear of the spring. Both the spring and screw are easy to locate when the machine has a separate bobbin case. When the machine has a drop-in bobbin with a built-in bobbin case, locating the tension screw can be more challenging.
What should tension be set on sewing machine?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
Where is tension on sewing machine?
Perfect sewing machine tension occurs when the top and bottom threads are perfectly balanced. That means you shouldn’t see any little loops on either the top or bottom of your fabric and the stitching should look even on both sides.
What is the tension setting on cotton?
Cotton requires a moderate tension setting, usually between three and four. Always start adjusting your tension settings with your upper tension.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
How do I know if my bobbin tension is correct?
The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.
When should I adjust the tension on my sewing machine?
When lower tension is too loose (or upper tension is too tight), knot is visible on right side (left). When upper tension is too loose (or lower tension is too tight), knot is visible on wrong side (right). Tensions can still need adjustment even if they’re balanced.
What tension should I use for thin cotton?
Use size 70/10 for really thin cotton like voile, size 80/12 for light to medium weight cotton, and 90/14 for thick cotton like denim.
What tension should I use for stretchy fabric?
For a stretchy fabric, it would be best if you set the upper tension level between 3-4. This adjustment is also a neutral level of tension setting. Step 5: Now, after you have attached the correct needle, stitch type, and tension setting, it is time to test the final stitch on your fabric.
How do you tighten thread tension?
Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension. Some quilters keep two bobbin cases on hand, leaving one as-is from the factory and using the other when they need to make adjustments.