Try reinserting the bobbin into the bobbin case and then put your finger on the bobbin so it cannot move then when you pull the thread into the tension on the bobbin case the thread will be pulled firmly into the tension on the bobbin case. This should resolve that issue.
Why does my sewing machine keep looping underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
Why can’t I get the tension right on my sewing machine?
When the bobbin thread shows on the right side, the needle tension is too tight or the bobbin thread, too loose, as shown at left in the illustration below. When the needle thread shows on the wrong side, the needle tension is too loose or the bobbin thread, too tight, as shown at right in the illustration below.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
What causes bobbin thread to bunch up?
Bobbin Thread Tangling
The bobbin keeps pulling and jamming collecting a lot of thread beneath your fabric. There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly.
How do you adjust bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
How do you adjust top stitch tension?
Adjust your top tension if it’s too tight.
To decrease your top tension if it is too tight, turn your knob so the numbers are decreasing. Try ½ to 1 number lower, then test the stitches on a piece of scrap fabric.
How do you adjust thick fabric tension?
The thicker the fabric, higher the tension must be to lift the lower thread up to the middle of the layers of fabric. You will usually be alright with a 4 or 5 on medium to medium-heavy fabrics like linen and twill weaves such as drill and denim.
What tension should I use for stretchy fabric?
For a stretchy fabric, it would be best if you set the upper tension level between 3-4. This adjustment is also a neutral level of tension setting. Step 5: Now, after you have attached the correct needle, stitch type, and tension setting, it is time to test the final stitch on your fabric.